Shaft diameter on the Bulldog Powered-Drive Camper Jack # BD500200
Question:
What is the shaft diameter for this product? I assume it is standard size which is for 2 1/4 hole in the camper A frame. Is the bolt pattern also standard? Thanks.
asked by: Garry
0
Expert Reply:
The Diameter of the main tube is 2-1/4 inches on the Bulldog Powered-Drive Camper Jack, item # BD500200. There are 6 holes in the mounting plate for either 2-1/2 inch mounting pattern or 3 inch mounting pattern. These are the standard bolt patterns used by most trailer manufacturers.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Dimensions for Installation of a Bulldog Electric Powered Trailer Jack with Propane Tanks on Tongue
- Q&A: Electric Trailer Jack Recommendation for a 7,500 lb Boat Trailer
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Q&A: Is Install of B and W Hitch for 2019 Ram 3500 Different from 2500
- Article: Best Camper Jacks
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 2023 Best Gifts for RVers & Campers
- Q&A: How to Wire the Bulldog Powered-Drive Trailer Jack # BD500200 on a Trailer with No Battery
- Q&A: Recommended Electric A-Frame Jack For 16-Ft Airstream Bambi Trailer
- Q&A: Can I Turn The Trailer A-Frame Jack To Achieve Clearance For My Lift Gate/Tailgate?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Maintenance Schedule
- Article: 2023 Best Gifts for Haulers & Towers
- Article: Trailer Tire Sizing