Measurement for Mounting Flange Bolt Pattern on Demco Hydraulic Drum Brake Assembly # 40716
Question:
how is the mounting flange bolt pattern taken 4 on 4inch Top left to top right or Top left to bottom right diagonal my existing flange is 3 inch top left to top right and 4inch diagonal I have the above number being shipped will they work
asked by: Mark R
0
Expert Reply:
I went out to our warehouse to grab the Demco Hydraulic Drum Brake Assembly, # 40716, and took a couple pictures to show you the location of the mounting holes. From the pictures you can see that the 4 inch measurement that is listed for the bolt pattern is measured diagonally. Hope this helps.
expert reply by:
Leah S
0
![Leah S](https://images.etrailer.com/static/images/catg/people/631_tn.jpg)
Product Page this Question was Asked From
Demco Hydraulic Drum Brake Assembly - Free Backing - Galvanized - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Free Backing
- 10 x 2-1/4 Inch Drum
- Demco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Is The Distance From The Brake Mounting Flange To Tip Of Spindle On # 84 Spindle TRU74FR?
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Q&A: Grease Seal to Replace Part Number 174253tb
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Recommended Surge Brake Actuator for a 3" x 5" Tongue
- Article: Transmission Cooler
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Recommended Brake Fluid for Demco Brake Actuators
- Q&A: Trailer Jack Recommendation For 14,000 Lb A-frame Dump Trailer
- Article: How to Measure a Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Measuring a Trailer Tire
- Article: Where to Position the Trailer Axle?