What Hardware is Needed to Install Channel Tongue Trailer Coupler # CT-3001-Z
Question:
I believe this CT-3001-Z is the product I need however I live an hour from a hardware store. Is the mounting hardware included? If not, what size and grade should I use? Also what is the diameter of the holes?
asked by: John
Expert Reply:
I pulled the Channel Tongue Trailer Coupler, # CT-3001-Z, from our warehouse and the installation instructions state that you should use 1/2 inch diameter, grade 5 bolts and locknuts to mount this coupler to the trailer tongue. They said that it is acceptable to use 4 separate bolts or two long bolts passing through all four holes. You can also add two bolts to the top holes for extra strength.
Product Page this Question was Asked From
Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 3,500 lbs
- Straight Tongue Trailer Coupler
- Standard Coupler
- 2 Inch Ball Coupler
- Bolt-On
- 3500 lbs GTW
- 2 Inch Channel
- Trigger Latch
- etrailer
more information >
Continue Researching
- Shop: Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 3,500 lbs
- Shop: Dexter DX Series Electric Over Hydraulic Brake Actuator for Disc Brakes - 1,600 psi
- Article: Best Boat Trailer Jacks
- Shop: CE Smith Single Axle Trailer Fender - Pre-Galvanized Steel - 12" Wheels - Qty 1
- Shop: Single Axle Trailer Fender for Boat Trailers - Steel - 10" to 12" Wheels - Qty 1
- Shop: Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diode - Oval - Red Lens
- Shop: Hydrastar Electric Over Hydraulic Actuator for Disc Brakes - 1,600 psi
- Search Results: dexter electric over hydraulic
- Shop: Bright Way Push-to-Test Trailer Breakaway Kit with 2-Amp Charger and 10 Ah Battery - Top Load
- Q&A: What Does a Trailer Tire Load Range Mean
- Search Results: boat trailer brakes
- Search Results: coupler pin
- Search Results: hitch mount
- Search Results: trailer light lens replacement
- Video: Review of Draw-Tite Trailer Hitch Ball Mount - Fixed Ball Mount and 2 Inch Ball - DT49MR
- Search Results: winch post assembly
- Q&A: Does the Draw-Tite Ball Mount DT49MR Come With Hitch Ball
- Search Results: dt49mr
- Q&A: Troubleshooting Trailer Wheels that Toe Out Toward the Front
- Q&A: Does Demco Coupler part # 12564 Come with Install Bolts
- Q&A: What Grade Bolts Are Recommended To Install Demco Channel Tongue Trailer Coupler
- Q&A: What kind of Bolts Do I Need for the Demco Channel Tongue Trailer Coupler?
- Video: Review of etrailer Straight Tongue Trailer Coupler - Standard Coupler - CT-3001-Z
- Article: Trailer Wiring Diagrams
- Q&A: Can I Remove A Weld-On Trailer Coupler and Replace it With A Bolt-On Coupler?
- Video: etrailer Channel Tongue Trailer Coupler Review