Distance from Centerline of Shaft To Centerline of Weld On Sleeve on Bulldog Drive Kit
Question:
What is the distance from the centerline of the shaft to the centerline of the weld on sleeve? Does the motor have to be mounted in the verticle position or can it be rotated slightly?
asked by: Randy D
0
Expert Reply:
I spoke with my contact at Bulldog and he informed me that the Bulldog Powered-Drive Kit part # BD1824200100 measures 5 inches from center of motor drive shaft to center of torque stop tube.
It's recommended to install it according to the instructions, if lack of room can mount other side of jack. Other than that there's no reason you have to mount it completely vertical.
expert reply by:
Jameson C
0
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Measure a Trailer Axle
- Q&A: Will Bulldog Powered Drive Kit Fit a Fulton 12K Magnum Jack
- Q&A: Can the Rain Sensor on a MaxxAir Vent be Overridden
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Article: Trailer Tire Sizing
- Q&A: Trailer Tire Size to Replace 8.75R16.5 Tires
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Q&A: Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Q&A: Replacement Entry Door Lock On A 2004 Featherlight Horse Trailer
- Article: Trailer Wiring Diagrams
- Article: Pintle-Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Trailer Maintenance Schedule