Recommended Replacement Part for an Elixir Vent with Four Tooth Hinge
Question:
My vent cover is an elixir with the four tooth hinges looking al lot like your jenson ventmate part. what cover do I need? thx
asked by: Al
0
Expert Reply:
To determine which cover is a fit for your application, you will want to check the size of your current vent cover (14 inches x 14 inches or 14-1/4 inches x 14-1/4 inches) and the hinge system it uses.
Based on your question, your application likely uses a 14 inches x 14 inches Plastic Frame Vent with a four tooth hinge. If so, part # CAM40147 will work for you.
expert reply by:
Chris O
0
Product Page this Question was Asked From
Camco Replacement Lid for Jensen RV Roof Vent w/ Pin-Style Hinge - Polypropylene - Smoke
- RV Vents and Fans
- Replacement Lid
- Roof Vent
- 14W x 14L Inch
- Plastic
- Tinted
- Camco
more information >
Continue Researching
- Article: How to Replace an RV Roof Vent Cover
- Q&A: Replacement Cover for Jensen Z26 AS 13 Roof Vent
- Q&A: Replacement Stud Recommendation for Dexter 6k Rated Trailer Hubs
- Q&A: Replacement Vent Cover for Hengs Roof Vent Model 122112
- Q&A: Trailer Hitch Fit for 2019 Ford Edge Titanium Recommendation
- Q&A: Vent Cover Attachment for Jensen RV Roof Vent
- Q&A: How to Determine the Correct Replacement Vent Lid for a Trailer Roof Vent
- Q&A: Replacement Motor for a Fan-Tastic Vent with 17 rpm 6051-05 Motor
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Replace or Install an RV Roof Vent
- Article: Best RV Roof Vents