Torque Specs for Dexter 10" Brake Assemblies
Question:
Hi, what is the torque spec for the studs on these brakes? -Patrick
asked by: Patrick D
0
Expert Reply:
According to Dexter Axle, the attachment bolts for a 10" brake assembly like item # K23-472-473-00 should be torqued to 30-50 foot/lbs. You will basically want to tighten the bolts until the lock washers flatten out.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Dexter Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3,000 lbs
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Manual Adjust
- 10 x 1-1/2 Inch Drum
- 3000 lbs Axle
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Storage Latch For The Furrion RV Refrigerator # FCR14ACBQASS
- Q&A: Replacement Lid and Lift Arm for Dometic 810263
- Article: Trailer Wiring Diagrams
- Q&A: What Size Braking Assembly Does a 3,000 Lb Trailer Axle Use
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Most Popular Wheel Bearings
- Q&A: Recommended Replacement For An Innoflame RV42D80F-C1 Fireplace
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Why Would Trailer Brakes Get Warmer on One Side When Brake Controller is Used
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Correct Replacement for Tru-Ryde Hub/Drum RVD-H-545
- Q&A: How Thick Are Electric Brake Shoe Pads and When Should They be Replaced