What Size Hole Saw for Installing Mighty Cord Replacement RV Power Inlet # A10-50INVP
Question:
This will be used on a conversion trailer. So there is no preexisting hole to install. What size hole saw would I use to create the mounting hole? Thank You
asked by: Wayne
0
Expert Reply:
Hey Wayne, the portion of the outlet part # A10-50INVP that you referenced that sticks through the wall of the trailer is 2-1/4 inch in diameter so I would go with just a little larger than that for an easier install like 2-5/16 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Mighty Cord Replacement RV Power Inlet - Twist Lock - 50 Amp - White
- RV Power Inlets
- Power Inlets
- 50 Amp Twist Lock Male Plug
- Square
- White
- Mighty Cord
more information >
Continue Researching
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Is the HydraStar # HBA-CAM Adapter Compatible with a HydraStar with Serial Number 310837
- Q&A: Replacement 4 Wire HBA-CAM for Older Carlisle Hydraulic Trailer Brake Actuator
- Article: Trailer Wiring Diagrams
- Q&A: How to Correctly Position Ramp Door Spring for Installation
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Mount a Truck Bed Camper
- Q&A: Difference Between RV Faucet and Home Faucet
- Q&A: Replacement 50 Amp Inlet Socket for RV
- Q&A: Power Inlet for DIY Build/Ambulance Camper Conversion
- Q&A: How to Install a Brake Controller on a 2020 Ford Transit T-250
- Article: How to Raise Your Travel Trailer Height
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: How Much Solar Power Do I Need For My RV?
Wayne
6/18/2024
Thank you sir