What Does ER Error Code of Brake EVN Brake Controller Mean
Question:
Have a 2019 Chevrolet Silverado 1500. Have the Reese Brake EVN it flashes Er error code. Does it have to be replaced? Would this be the correct one?
asked by: Rick G
0
Expert Reply:
Hey Rick, so the ER error code of the Brake EVN brake controller part # TK63VR means it has an internal problem and in need of replacing. You might try unplugging the controller and plugging it back in as a hard reset MIGHT help clear out an internal bug but most likely it's just fried.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Tekonsha BRAKE-EVN Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Up to 4 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement 7-Way Trailer Connector W/ Brake Controller for a 2024 Toyota Grand Highlander
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Does 2020 Toyota Tacoma Need Brake Controller to Activate Travel Trailer Brakes
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: Troubleshooting Titan BrakeRite EHB Electric-Hydraulic Disc Brake Actuator # T4813102
- Q&A: Motor Runs on Brake Rite EHB Electric Over Hydraulic Actuator but Does Not Build Pressure
- Q&A: Replacement Bunk Brackets for Escort Boat Trailer
- Q&A: Bearings and Seal for Replacing UFP Dexter 41062 Hub with Kodiak Hub and Rotor