Which Maxxair Roof Vent Cover is Designed to Fit the Ventline Ventadome RV Roof Vent
Question:
@JamesonC I have the V3094 model Ventline Ventadome Roof cover with the four mounting points on top. What Maxxair will mount to those? I’ve tried the original Maxxair but doesn’t work
asked by: Rich
0
Expert Reply:
Hey Rich, the standard Maxxair roof vent cover part # MA00-933066 is what Maxxair recommends to fit your Ventadome. This cover was designed to match up with the 4 mounting points on the Ventadome.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
MaxxAir Standard Roof Vent Cover - 20" x 19" x 9-1/2" - Translucent White
- RV Vents and Fans
- Vent Cover
- Roof Vent
- 18-1/2W x 19L Inch
- Plastic
- White
- MAXXAIR
more information >
Continue Researching
- Q&A: Is 3/4" Wide Butyl Tape Wide Enough For The MaxxFan MA00-07000K?
- Article: How to Replace an RV Roof Vent Cover
- Q&A: Complete AC System With An Advent 13.5K BTU Low Profile AC Unit
- Q&A: Trailer Hitch and Cargo Carrier to Hold Honda EU3000is Generator on Back of Jayco Travel Trailer
- Q&A: How Much Space Is Needed To Remove MORryde StepAbove RV Steps From A Trailer
- Q&A: How to Determine Which Trailer Roof Vent Cover will Fit a Trailer
- Q&A: Is The Screen on the Vision S Camera System Brighter Than The Original Vision Camera Monitor?
- Q&A: Replacement for a Carrier Air V RV Air Conditioner
- Article: 2023 Holiday Must Haves
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: How to Replace or Install an RV Roof Vent
- Article: How (and Where) to Connect an RV Propane Grill
Rich
5/28/2024
Thanks James. FYI to others with same vent cover. Had to carefully cut away excess roof sealant from in from of the mounting holes.