Does the Lippert 6 Point Leveling System Need to Be Reset When Installing
Question:
When installing a new lippert 6 pt control module, do i need to reset the new module or is it set at the factory?
asked by: Dave M
0
Expert Reply:
It is set at the factory, Dave. You just need to pop the new control module for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad # LC358590 in and you'll be all set.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Q&A: Which Snappads for 2025 Entegra Aspire
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Article: How to Raise Your Travel Trailer Height
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review