Does Truck Bed Camper Need To Overhang For Brophy Camper Jacks To Work?
Question:
Is camper overhang required for the jacks to work?
asked by: Nickie
0
Expert Reply:
Yes, technically the camper needs to hang over truck bed rails for the Brophy Heavy Duty Cable Camper Jacks - 67" Max Lift Height - 4,000 lbs # CX74 to get under the camper and lift it up properly. This should be self-explanatory, but if the camper doesn't fit the truck bed properly and doesn't overhang the proper amount, then the jack would be too close inside and possibly hit the truck tires.
expert reply by:
Andrew N
0
Product Page this Question was Asked From
Brophy Heavy Duty Cable Camper Jacks - 67" Max Lift Height - 4,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 3001 - 4000 lbs
- Sidewind Jack
- 67 Inch Lift
- 2 Jacks
- Brophy
more information >
Continue Researching
- Q&A: How Much Fender Clearance Does The Brophy Heavy Duty Cable Camper Jacks Offer
- Q&A: Truck Bed Camper Jacks for 1970's Ford Slide-In Camper
- Q&A: Comparing Brophy CX74 and CJ74 Camper jacks
- Q&A: Can Valterra Folding Manual Stabilizer # 020106 be Used to Stabilize a Truck Camper
- Q&A: Are The Brophy Cable Camper Jacks Stable
- Q&A: Replacement for Atwood Truck Camper Jacks for Lancer Camper Model 1050S
- Article: How to Mount a Truck Bed Camper
- Q&A: Using an Electric Winch to Raise and Lower a Ramp Door on a Logan Horse Trailer
- Article: Performance Chips and Modules
- Article: Ram Trailer Tow Prep Package
- Article: Flat Towing Package for 2011-2014 Ford F-150