Can Second Conventional Style Ramp Spring be Added to RV Door
Question:
Hello. I am looking to purchase the 7 foot ramp door spring kit. The 7ft 150lb single spring kit looks good. My question, is if I can add a second spring to this later? If needed after instalation. Make it 300lbs. Thanks.
asked by: Matt
Expert Reply:
Hey Matt, it would be pretty difficult to install two of the ramp door springs part # 362SA7 at the same time so it's going to be best to just use the one. You most likely will find that you don't have to have it fully wound to get enough spring to make lifting the ramp easier but you could potentially wind it tighter at that point to get it to help lift even more.
Product Page this Question was Asked From
Conventional Ramp Door Spring for 7' Wide Enclosed Trailer - Single Spring - 150-lb Capacity
- Trailer Ramp Springs
- Single Ramp Spring
- Conventional
- 150 lb Capacity
- 79 Inch Wide Spring
- 79 Inch Wide Doors
- 4-7/8 Inch Tall Spring
- Steel
- TRC
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Ramp Springs For 6 Foot 6 Inch Trailer Door
- Q&A: Measuring Enclosed Trailer Ramp Door Weight For Torsion Spring Lift Assist
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Does Conventional Ramp Door Spring # 362SA7 Come with Rods for Winding Spring
- Q&A: How to Correctly Position Ramp Door Spring for Installation
- Q&A: What is the Difference Between the AirLift Wireless Compressor Systems 73000EZ & 74000EZ
- Q&A: Recommended Ramp Door Spring for 6x12 Enclosed Trailer
- Q&A: Will 10 x 2-1/4 Inch Trailer Brake Shoe Pads Part BP04-095 Fit 10-Inch Nev-R Adjust Brake Assembly
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Measure a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: Trailer Maintenance Schedule