Is There An Installation Video For The Roadmaster Baseplate # RM-523182-5

Question

Question:

2019 chevy colorado 4x4 roadmaster base plate installation video. Do you have an installation video avaliable?

asked by: David C

0

Expert Reply:

Hi David,

Yes, we do have an installation video for the Roadmaster Direct-Connect Base Plate Kit # RM-523182-5 on a 2019 Chevy Colorado, which I've attached below.

expert reply by: Kevin C

0

Answer 1

Hey David, The Roadmaster Guardian Rock Guard for Towed Vehicles #RM-4000 was only designed to work with Roadmaster's crossbar-style baseplates and there isn't an adapter available to convert it over to direct-connect. You could try selling…

view full answer...

Answer 2

As long as your 2017 Chevrolet Colorado does not have the adaptive cruise control you will be able to use the Roadmaster Direct-Connect Base Plate Kit - Removable Arms #RM-523182-5 which will pair up perfectly with the Roadmaster Sterling All…

view full answer...

Answer 3

Yes I attached an install video that shows the Roadmaster EZ5 base plate kit #RM-523182-5 installed on a 2019 Chevy Colorado for you to check out.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 11

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Is There An Installation Video For The Roadmaster Baseplate # RM-523182-5

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching