Recommended Replacement Landing Gear Legs and Rebuild Kit for a 2007 Dutchmen Northshore
Question:
I have a 2007 DutchmenNorthshore 28lbs with wheel and my drivers side lead landing gear doesnt not raise up unless constant pressure is applied to the leg then it will go up about half way pulled the cap off the leg and the gears are loose would I need a whole leg or can I just replace the gears attached is the tag on the inside of the cap
asked by: Brad S
Expert Reply:
Thanks for the picture, Brad. If the leg is in good shape otherwise, I'd recommend just going with a rebuild kit opposed to a whole leg.
You can use the Lead Jack Repair Kit for Stromberg Carlson Landing Gear # LG-146059 for the lead legs and # LG-146060 for the follow leg.
If you decide that you do want to replace the entire leg, then you'd need the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear # LC119102 for the lead leg or the Replacement Follow Leg for Venture 5th Wheel RV Landing Gear # LC119101 for the follow leg.
Products Referenced in This Question
Replacement Follow Leg for Venture 5th Wheel RV Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Follow Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Replacement Follow Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Stromberg Carlson
more information >
Continue Researching
- Q&A: What Does E6 Furrion Thermostat Indicate
- Q&A: Landing Gear Repair Kit for Venure VMC900L Follow Leg
- Q&A: Replacement Part Availability for Venture VMC900L Landing Gear
- Q&A: Replacement Follower Leg for a Venture VMC900L Landing Gear Set
- Q&A: Replacement Lead Leg for VMC900L with Stripped Thread/Nut
- Q&A: Recommended 5th Wheel Hitch Compatible with CMI 5th Wheel Rails
- Q&A: Follower Landing Gear Leg Recommendation for a 2005 Carriage Fifth Wheel Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Jacks
- Article: How to Measure for Trailer Hitch Drop
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
Brad
5/14/2024
If I replaced the leg how can I tell for sure if it's a weld on or non weld on leg