Mounting Hole Dimensions on Sliding Under Platform Pontoon Boat Ladder
Question:
what the the mounting hole dimensions?
asked by: Ryan
0
Expert Reply:
If you're wanting the size of the pre-drilled mounting holes on the # 315-FOG4 they are 1/4". If you're looking for the distance between the mounting holes I have attached a diagram below showing the measurements.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Sliding Under Platform Pontoon Boat Ladder - 4 Steps - 45-1/2" Tall - 400 lbs - Stainless Steel
- Boat Ladders
- Pontoon Boat Ladder
- 44 Inch Tall
- 4 Steps
- Stainless Steel
- Jif Marine
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Mobile Home Axle Conversion to Electric Trailer Brakes
- Q&A: Adding Brakes to a Mobile Home Axle
- Q&A: Troubleshooting Surge Brakes Locking Up When Moving Forward
- Q&A: Best Weight Distribution for a V-Nose Trailer with Short Frame Distance from Coupler to Body
- Article: How to Charge a Dump Trailer Battery
- Q&A: Location of Heating Element on Atwood GC6AA-10E Water Heater
- Q&A: 205/75R14 Size Trailer Tire Needed with Load Range D and Speed Rating of at Least 81 mph
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: How to Measure a Trailer Axle
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV