What Happens if Trailer Leaf Spring Shackle is Almost Flat
Question:
Hello, when I ordered my new leaf springs I measured the existing mounting holes but didnt account for any sag once the load was put on them. The shackles are pushed pretty far to the rear after the jack was lowered. Do you think this will be OK?
asked by: Tom L
0
Expert Reply:
Hey Tom, thanks for the picture. So the problem will be that when you hit a bump the spring will run out of room to flatten out so the suspension will essentially get very hard at that point and the trailer will bounce pretty hard. I would recommend going with a shorter length spring or moving your hangers out further.
expert reply by:
Jameson C
0
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Product Page this Question was Asked From
3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 23-1/2" Long
- Trailer Leaf Springs
- Double Eye Springs
- 2000 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 23-1/2 Inch Long
- Painted
- Universal Group
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Can I Install Heavy Duty Leaf Springs On My Keystone Outback Travel Trailer?
- Q&A: Dimensions of Hangers and Equalizers on Tandem Axle Suspension on 16-Ft Trailer
- Q&A: Determining Correct Replacement Equalizers and Shackle Straps for Older Trailer
- Q&A: Troubleshooting Right Brake Light on Trailer Not Working But Right Turn Signal is Working
- Q&A: How to Fix a Pitted Spindle
- Q&A: Do Hubs Need to be Replaced When Replacing Trailer Brakes
- Q&A: How To Raise a Keystone Outback Trailer with Tandem 3 Inch Axles
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Double-Eye Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Slipper Spring Trailer Suspension System Review