Is There A Snap Ring Jack With A Wheel That Uses a 1/2" Pin For The Mounting Plate?
Question:
I have a EZ loader boat trailer that had a Fulton trailer Jack attached at the factory. That jack went bad on a trip and was replaced with a different jack but only had a flat plate in place of a wheel. I would like to replace the jack with a trailer jack with a wheel but the welded mounting plate was modified to support a pin that is 1/2 in. All the Fulton jacks I see advertised have only a 3/8 in pin. Do you have a boat trailer jack that is held on with a C clip and has a 1/2 in pin?
asked by: John K
Expert Reply:
Hello John. After looking thru all of the snap-ring jacks we carry, I am sorry to say that we do not offer anything with a wheel that will also use a 1/2" pin. We do have a jack with a wheel and a snap ring that uses a 3/8" pin, the Fulton # FTJ120W0301. We also have one snap ring jack that does use a 1/2" pin, part # TJB-2001-Z, but as lock would have it, this jack has a welded foot plate instead of a wheel.
I know neither of these options fit your description exactly, but these will be the closest options we can offer.
Products Referenced in This Question
Round Snap Ring Swivel Jack w/ Footplate - Weld On - Zinc - Topwind - 10-1/2" Travel - 2K
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Swivel Jack
- Topwind Jack
- 11 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Product Page this Question was Asked From
Fulton Round, Snap-Ring Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Continue Researching
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Is There a Replacement for a Shelby Jack 5856A That Uses Existing Bracket
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Jack Recommendation for Shelby # 5856A
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Article: Best Boat Trailer Jacks
- Article: Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: Pintle-Hitches
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
John
4/23/2024
Jesse Thanks for the reply, I did look at the FTJ120W301 video and it looks like it will work as long as I weld the new plate to the trailer tung. I will go ahead and order that jack. Thanks for your help. John Kearns