Instructions For Replacing Dometic Float Switch # DOM96FR
Question:
Is there a how to replace the existing sensor? Mine appear to be glued in place.
asked by: Jon D
0
Expert Reply:
Hello Jon. I was able to track down the instructions for replacing the empty and mid floats. This should give you a general idea of how to replace the full float switch. See the image attached below.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Replacement Sensor for Dometic RV Holding Tank Monitoring System - 1/2" Grommet - 24" Wire
- Accessories and Parts
- RV Toilets
- Tank Full Float
- Dometic
more information >
Continue Researching
- Q&A: Replacement For Atwood 91349 Control Panel
- Q&A: 3000 Watt Go Power Inverter/Charger Sub Panel Install Diagram
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Replacement Oven and Stove for Magic Chef CLY222OBDB
- Q&A: Replacement for Power Gear Slide Out Motor 520317
- Q&A: Wiring Diagram for Dometic Single Zone Thermostat and Control Box
- Q&A: Replacement Sewer Wye for Bristol V33B2R on Cobra Salem RV
- Q&A: Replacement Control Module for Coach Steps Model 202-3207
- Article: How (and Where) to Connect an RV Propane Grill
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?