How To Remove Light Cover To Replace Screw
Question:
I have this light as an exterior porch light. One side has pulled off, just need a slightly bigger screw. How can I take this apart without breaking it or damaging my trailer?
asked by: Tony B
0
Expert Reply:
Inserting a flathead screwdriver in those cutouts and applying pressure should allow you to pop off the cover of the light. From there you will be able to see the mounting holes and replace the screw. If this is an Optronics Opti-Brite like # ILL70CBSBAWN the mounting hole diameter is 3/16".
expert reply by:
Robin H
0
Product Page this Question was Asked From
Opti-Brite LED Strip Light w/ Switch for RV Awnings - Weatherproof - Black Housing - 11" Long
- LED Strip Lights
- Flexible Light
- Interior Light
- Awnings
- Hardwired
- 11 - 20 Inch Long
- Cool White
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Replacement Fan Motor And Blade For Ventline P Series Range Hood
- Q&A: Can I Install the Thinline LED Trailer Tail Light Vertically Where It Will Be Submerged?
- Q&A: Reverse Light PIn on a 7-Way Trailer Connector
- Q&A: Hitch Pin Weight Capacity and Sheer Strength
- Q&A: Can FloTool RhinoRamps Max Vehicle Ramp Set Hold the Weight of a 2021 Ram 3500
- Q&A: What Axle Capacity is the Replacement Trailer Brake Magnet for Dexter Electric Brake BP01-225 For
- Q&A: Replacement Brake Shoes and Brake Magnets for Dexter 4.4K, 10 inch x 2-1/4 inch Trailer Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Replace an RV Roof Vent Cover
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs