Can Replacement Gear Kit for Bulldog Sidewind Jacks Retrofit Old Bulldog Jack
Question:
I have an older Bulldog 12 Series 180 that needs to be rebuilt. I cant find a model number on it. I have watched the video on part BD500212 and the parts are not even close, no spring, the pin will have to be ground off to be removed, ect. Can this kit be used to retrofit? I think that the part that has failed can be replaced by part BD500217. I wont know until I can get the gear mechanism out. Thank You Chester Briscoe
asked by: Chester B
Expert Reply:
The # BD500212 is only designed as a replacement kit. It may be possible to retrofit but we have never tested it. Bulldog may have more information on this but I'm guessing they will say to completely replace the jack. The BD500217 is on extended backorder so I don't know when we will get it back. You may be able to find it elsewhere to attempt a repair.
Product Page this Question was Asked From
Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Bulldog
more information >
Continue Researching
- Search Results: bd500212
- Search Results: bd500217
- Video: Bulldog Square Jacks Rebuild using Replacement Screw and Nut Assembly
- Shop: Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Video: Rebuilding a Bulldog 12000-lb Capacity Jack
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Shop: Opti-Brite 12V/24V LED RV Dome Light - Single - 6-3/4" Long x 3-15/16" Wide - White Trim
- Shop: RV Interior Lighting
- Shop: Optronics LED RV Utility Light - Submersible - 168 Lumens - Round - Chrome Trim - Clear Lens
- Shop: RV Exterior Lighting
- Shop: Provider ST235/80R16 Radial Trailer Tire w/ 16" Silver Mod Wheel - 8 on 6-1/2 - LR E
- Shop: Bulldog Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Shop: Cross Shaft Extension Tube for Bulldog Tandem Landing Gear - 72-3/4" Long - Fixed
- Search Results: 44649
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Shop: Trailer Wiring
- Search Results: 68149
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Search Results: 25580
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: Trailer Tire Sizing
- Shop: Fifth Wheel Hitch
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500
- Shop: Brake Controller