How to Remove Nev-R-Lube Bearing from Hub
Question:
how do you get never lub bearing out of hub
asked by: Richard J
0
Expert Reply:
Hey Richard, thanks for reaching out!
In order to remove the old bearing so you can install the 50MM Nev-R-Lube Bearing # 31-71-3 you'll need to use a press or bearing removal tool kit.
Dexter Axle actually recommends using "an arbor press and mandrel" to press the bearing out on the wheel side of the drum. We don't have any kit like this so you'll need to source this locally or elsewhere online.
expert reply by:
Jon G
0
Product Page this Question was Asked From
50MM Nev-R-Lube Bearing for 8,000-lb Dexters - Qty 1
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 50 MM I.D.
- Bearing 31-71-3
- 8000 lbs Axle
- Dexter
more information >
Continue Researching
- Q&A: What Is the Torque Spec for a Nev-R Lube Spindle Nut
- Q&A: Procedure for Replacing 31-71-3 50mm Sealed Nev-R-Lube Bearings
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: Do Nev-R-Lube Bearings Last a Long Time
- Q&A: Do You Grease Inside Of Dexter Nev-R-Lube Hub Or On The Spindle Before Installing The Hub?
- Q&A: When to Replace Dexter Nev-R-Lube Bearings
- Q&A: Replacement Hose for Marshall Gas M4 Flexible Hose Connector with a Female Flare Fitting
- Article: Trailer Wiring Diagrams
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch
Richard J.
4/10/2024
Thanks