Does Amp Hour of Battery Bank Need to be Set of the Go Power RV Battery Monitor Kit GP44FR
Question:
I purchased this panel and I replaced my single 100AH AGM battery with 4 each 100AH lithium batteries in parallel... I replaced the solar controller, wires and fusing as appropriate. BUT this remote display shows 100 charge but it also says 100AH... Why doesnt it now read 400AH? Probably a really newbie question so apologies in advance.
asked by: Paul L
0
Expert Reply:
Hey Paul, you actually need to go in and set the max amp hour capacity of your battery bank in the settings of the Go Power monitor part # GP44FR. If you check out page 5 and 6 of the attached install instructions link you can see how to do this.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Go Power RV Battery Monitor Kit with 25' Cable
- Accessories and Parts
- Battery
- Battery Monitor
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Where are Seaflo Battery Disconnect Kits Made
- Q&A: Does the Go Power RV Battery Monitor Kit Draw Power From the Battery
- Q&A: Can Go Power RV Battery Monitor Kit with 25' Cable # GP44FR Work on Battery Bank
- Q&A: Is Go Power GP44FR RV Battery Monitor Kit Compatible With Lithium Batteries
- Q&A: Are Other Parts Needed to Mount 30 Amp Go Power PWM Solar Charge Controller GP76QR
- Q&A: Will A 30 Amp Solar Charge Controller Charge Batteries Faster Than A 10 Amp Solar Charge Controller
- Q&A: Where is the Factory Trailer Brake Controller Port On a 2022 Chevrolet Tahoe
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: 4-Step Guide to Installing RV Solar Power
- Article: What is Boondocking
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Using a Portable Generator on RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How Long Can You Boondock in an RV?