Can The Optronics LED Light Strip # UCL90CB Be Cut In Half?
Question:
can i , cut this in half and run on both sides of my trailer frame. If so how do I connect the other side with no wire leads to the power source
asked by: Scott H
0
Expert Reply:
Yes, you can cut the Optronics Flexible LED Light Strip # UCL90CB in half and run both sides down your trailer frame. There is actually a short wiring lead on both ends of the strip so you will have what you need to wire both sections. Do be sure to use some sealant like Liquid Electrical Tape # SWC50122 to seal up the ends where you cut it in half.
expert reply by:
Bud M
0
Products Referenced in This Question
Product Page this Question was Asked From
Optronics Flexible LED Light Strip - Weatherproof - White - 17' Long
- Trailer Lights
- Utility Lights
- Strip Light
- Surface Mount
- LED Light
- 17L x 3/8W Inch
- White
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Q&A: Color of Light Output for the Optronics Flexible LED Light Strip # UCL90CB
- Q&A: Optronics Flexible LED Light Strip # UCL90CB Wire Gauge
- Q&A: Recommended Weatherproof LED Strip Light for Keystone Montana 5th Wheel
- Q&A: Recommended LED Marker Lights for Trailer Over 80 Inches Wide
- Article: 2023 Best Gifts for Auto Enthusiasts
- Q&A: Replacement Converter for Magnetek 7300 in Airstream
- Q&A: Where to Install Buyers Products Door Check and Hold Back
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Tire Sizing
- Article: Determining Trailer Tongue Weight
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)