Troubleshooting Curt Trailer Wiring with 2.6 Volts on Running Light Circuit
Question:
Only getting 2.6 volts at the running light on a Curt T connector.
asked by: Mike
0
Expert Reply:
Hey Mike, that would be too low of voltage for the running light circuit to function. That would be an indicator that the converter box is bad. When it's time for a new harness I'd go with the Tekonsha part # 118741 as they tend to have more reliable converter boxes.
expert reply by:
Jameson C
0
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: All Parts Needed to Flat Tow 2014 Chevy Silverado 1500 Behind Motorhome
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Brake Controller Installation: Starting from Scratch
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly