Troubleshooting Passenger Side Tail Light and License Plate Light Not Working After Curt Wiring
Question:
I sintallwd the curt t connector and now my passenger side light isnt working. The blinker and stop light work. Also the passenger side license plate light isnt working. The trailer light works but it wont blink. Any ideas?
asked by: Donald R
Expert Reply:
It sounds like you most likely had a fuse blow when you installed the Curt wiring. This is a common occurrence as a small short could have caused enough power to jump through the circuit and pop the fuse. As far as the trailer light not blinking, you will want to use a Test Light # PTW2993 to verify if the issue is on the trailer only or if the 4-way itself is not functioning properly. While often rare it does happen where the converter will be bad from the factory.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150
- Article: Trailer Lighting Requirements