Recommended Weld-On Replacement For An Atwood 82541 Surge Brake Actuator
Question:
I have an Atwood 82541 weld on actuator with a bad master cylinder drum brakes w/lockout. The trailer tongue is C channel 3 wide x 1 tall extending 5 from A-frame. This doesnt seem like much room to weld, but is how it was made back in 1986. Is there an actuator you could recommend? Does it have weld instructions? Im hoping I can find one that allows me to weld on outside and partial inside edge to get as much weld length as possible with the limited tongue size.
asked by: Doug M
Expert Reply:
Hi Doug,
If the tongue really is C-Channel and not a box the you'd likely need to first weld a piece of metal to fill in the gap on the open end for the new actuator to weld onto. You could go with an actuator like the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout # DX63FR. You'd weld this to the top of the channel, but there aren't welding instructions included.
This actuator has a 7,500lb capacity, fits a 2" hitch ball, and comes with an electric reverse lockout solenoid so that you can back up the trailer.
Products Referenced in This Question
Dexter DX7.5L A-60 Brake Actuator w Electric Lockout - Weld On - Disc - 2" Ball - 7.5K
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Weld-On
- 7500 lbs GTW
- 2 Inch Ball Coupler
- Disc Brakes
- Electric Lockout
- Dexter
more information >
Product Page this Question was Asked From
Dexter DX7.5L A-60 Brake Actuator with Fill Cap - Bolt On - Drum - 2" Ball - Zinc - 7,500 lbs
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Bolt-On
- 7500 lbs GTW
- 2 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Dexter
more information >
Continue Researching
- Q&A: Where to Find Surge Brake Actuator Information on Trailer
- Q&A: Replacement Part Availability And Options For Replacing An Atwood Brake Actuator
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Troubleshooting A Bouncy Ride On A Vanleigh RV Vilano 325RL Fifth Wheel Trailer
- Q&A: Can Dexter Brake Actuator # DX89FR be Used with Tandem Axle Disc Brakes
- Q&A: Replacement Actuator Recommendation for Discontinued Atwood 85738
- Q&A: Recommended Replacement For A UFP Model A-70 Brake Actuator
- Q&A: How to Loosen Stuck Latch on an Atwood Hydraulic Brake Actuator
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Tire Sizing
- Article: Most Popular Wheel Bearings
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Couplers