How to Separate Trim Lights From Brake Lights on Diamond Cargo Trailer
Question:
How can I separate the trim signels and break signels on my enclosed trailer? 7 pin plug on truck and trailer 3 wires at rear for break, trim , and running lights
asked by: Joey C
Expert Reply:
Since these "trim" lights turn on with your brakes I'm assuming they also flash with the turn signal. Whatever wire is running to these lights is probably spliced into the left and right turn/stop circuit. All you need to do is disconnect that wire from the signal/brake wire.
I'm assuming you want them to work with the running lights so splicing them into what is typically the brown wire would do the trick. Colors aren't always true to function so it would be a good idea to test the wire functions with a circuit tester like # PTW2993 to make sure it you're connecting to the right wire.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Article: Determining Trailer Tongue Weight
Joey C.
3/20/2024
I was actually trying to get the yellow ones to flash with the turn signals and the long red leds to shine with the break lights