What is the Mid-Receiver Distance to Frame Bracket for Curt Front Hitch on a 2006 Dodge Ram 3500
Question:
Hello. I have a 06 Ram 3500, 4x4, 5.9L, SLT, with a multitude of front end undercarriage add ons, less a hitch receiver. For Curt 31017, could you give me the size as shown in the attached picture. The distance from the top of the flange to the center of the receiver. Thanking you in advance.
asked by: Gerard
0
Expert Reply:
Hey Gerard, thanks for reaching out!
The mid-receiver to frame bracket distance you're looking for is 2-5/8" for the Curt Front Mount Trailer Hitch Receiver # C31017 (see attached).
expert reply by:
Jon G
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 350 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Hitch Extension for Towing a Boat on a Truck with an In-Bed Truck Camper
- Q&A: Can I Use Both the 7-Way and 4-Way Connectors at the Same Time on a 2015 Chevrolet Silverado
- Q&A: Which Extension For Towing Boat Trailer With Truck Bed Camper In 2019 Chevrolet Silverado 1500
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Reese Extension/Reducer # RP45292 Compatibility with Class V Factory Hitch on 2013 Ram 2500
- Q&A: Taillight Replacement for Trailer with SAE Number 1ST P2-84-DOT
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Article: Hitch Adapters and Extenders
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Best Bike Racks for Electric Bikes
Gerard
3/20/2024
Jon, thank you for the same day reply. I did some measurements on my vehicle and I can make some truck accessory mods to get the Curt 31017 to work, but then I was seeing that Draw-Tite hitch 65046 may also work. Perhaps easier? Could I get the same dimension for the Draw-Tite 65046? Thank you. eTrailer is making my fabrication mods decision much easier!!!