Distance Between etrailer Electric Trailer Brake Bolt Holes
Question:
This is a 4 bolt pattern where it hooks up to the backing plate. On my trailer, the backing plate bolt spacing from center of bolt to center of bolt is 3. Will these fit
asked by: Will
0
Expert Reply:
The distance between the bolt holes on the etrailer Electric Trailer Brakes # AKEBRK-35-SA is 2-7/8" on center. I'm willing to bet this is actually the same as what you have and your 3" measurement was approximate. If you have 3,500 lb axles then I'm confident these will fit your brake flange bolt pattern.
expert reply by:
Robin H
0
Product Page this Question was Asked From
etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Most Popular Wheel Bearings
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Parts Needed To Add Electric Drum Brakes To A Pontoon Trailer
- Q&A: Finding the Correct Electric Trailer Brake Assembly for Lippert Components 2800 lb Axle
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Are New Brake Drums Required if Replacing Electric Brake Assemblies on a Trailer
- Q&A: Replacement Trailer Brakes for Dexter 023-217-00
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes