Looking For Hub/Drum Assembly To Replace Dexter 8-285-8UC3-A
Question:
I am looking for a brake/hub assembly P/N 8-285-8UC3-A the specs, are 8,000lb axle 8 on 6 1/2 bolt pattern with 5/8 wheel studs, 12 1/4x3 3/8 Ez-lube. The closet thing I came up with was the never-lube which I am not sure will work.
asked by: Randy H
Expert Reply:
Hello there Randy, we have just the thing! You can use the Dexter Trailer Hub and Drum Assembly # DX46XR to replace your 8-285-8UC3-A hub/drum assembly. It uses the same # 25580 inner bearing, # 02475 outer bearing, 8 on 6-1/2" bolt pattern, 5/8" studs and 12-1/4" diameter x 3-3/8" wide drum size. This also comes with all of your bearings, races, seal, E-Z lube grease cap and lug nuts.
Products Referenced in This Question
Dexter Trailer Hub and Drum Assembly for 8,000-lb E-Z Lube Axles - 12-1/4" - 8 on 6-1/2
- Trailer Hubs and Drums
- Hub with Integrated Drum
- EZ Lube
- 25580
- 02475
- For 8000 lbs Axles
- 5/8 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly for 8,000-lb Nev-R-Lube Axles - 8 on 6-1/2
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Nev-R-Lube
- For 8000 lbs Axles
- 5/8 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Dexter
more information >
Continue Researching
- Shop: Dexter Trailer Hub and Drum Assembly for 8,000-lb E-Z Lube Axles - 12-1/4" - 8 on 6-1/2
- Q&A: What is the Torque Spec of the Spindle Nut on a Dexter E-Z Lube Axle
- Q&A: Correct Replacement for Dexter Hub/Drum 8-415
- Q&A: Correct Replacements for Dexter 023-359-00 Left Hand and 023-360-00 Right Hand Braking Assemblies
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Q&A: How to Determine if a Torsion Axle Needs to be Replaced and Lifting a Trailer Off the Ground
- Q&A: Why is Timbren Axle-Less Trailer Suspension System Not Recommended for Triple Axle Setups
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Performance Chips and Modules