How is the Inner Tube Held In Place on the Pro Series Square Jack?
Question:
The inner tube on my Jack has fallen down. The leg is fully retracted. What holds the inner tube in place? I’ve watched a couple of videos and the only thing that I see that holds the inner plate in place is the pin under the gear. Would that be correct?
asked by: Chuck
0
Expert Reply:
It depends what jack you're using but yes that is how the inner tube of the Pro Series Square Jack item # PS1400950376, you were looking at, is held in place.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Pro Series Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Fifth Wheel Trailer
- Gooseneck Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 9001 - 10000 lbs
- Sidewind Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Dimensions for Attachment of the Pro Series Square Drop Leg Jack 12,000 Lbs. # PS1400950376
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Article: Trailer Tire Sizing
- Q&A: Replacement Parts for Pro Series 12000 Trailer Jack
- Q&A: Issue with Bearing Buddy Leaking Grease from Overfill Port
- Article: Trailer Wiring Diagrams
- Q&A: Torque Rating for Spindle Nut on Trailer Hubs
- Q&A: Does the Galeo Ride GPS Tracking Device for Bikes Come with Everything Needed
- Q&A: Roller Material on Gorilla-Lift Replacement Roller Assembly Part # GMNR925
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Trailer Jacks
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Slipper Spring Trailer Suspension System Review