Which Timbren Kit Fits 2013 Ram 3500 Single Rear Wheel

Question

Question:

What system do I need for a 2013 ram 3500 single rear wheel? Not dual wheel.

asked by: Mike

0

Expert Reply:

Hey Mike, the Timbren kit you need for your 2013 Ram 3500 single rear wheel is the part # TDR3500CA.

expert reply by: Jameson C

0

Answer 1

Since one of your goals is to reduce sag I suggest the Timbren system. The TorkLift StableLoad #TLA7311 is mainly for creating smoother ride and to avoid sway and body roll. The Timbren springs will help with sag while towing and won't affect the…

view full answer...

Answer 2

Yes, it does. The Spacer Kit for Timbren Suspension item #T68MR will work with the Severe Service Timbren Suspension Enhancement System item #TFRTT350J. This system is confirmed to fit the 2023 Ford F-250. It already includes a pair of 1"…

view full answer...

Answer 3

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 4

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 8

Hey James, The correct rear camper tie-downs to go along with your new TorkLift SuperHitch Original Trailer Hitch Receiver #TLD1102 are going to be part #TLR3505. These will mount directly to the hitch at the end of the crosstube.

view full answer...

Which Timbren Kit Fits 2013 Ram 3500 Single Rear Wheel

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching