Length From Back of Bulldog Cast Head Coupler # BD4420000317 to Center Of Ball Mount
Question:
What is the dimension from mounting face to center of ball?
asked by: Shawn
0
Expert Reply:
Sorry it took me so long to get you the measurement Shawn, as I had to wait to get the measurement for the Bulldog Cast Head Coupler # BD4420000317 from Bulldog. We did not have any in my local warehouse to measure but according to Bulldog it is 7-5/8" from the back of the coupler to the center of the hitch ball.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Bulldog Cast Head Coupler w/ Wedge Latch - 2-5/16" Ball - Flat Plate Mount - 20,000 lbs
- Flat Mount Trailer Coupler
- Fixed Coupler
- Bolt-On
- Weld-On
- 20000 lbs GTW
- 2-5/16 Inch Ball Coupler
- Trigger Latch
- Bulldog
more information >
Continue Researching
- Q&A: What are the Bolt Hole Sizes on the Bulldog Cast Head Coupler and Can it be Welded
- Q&A: Can the Gen-Y Hitch 5th Wheel to Gooseneck Pin Box Be Used in a Short Bed Ram 3500
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Q&A: What Coupler Lock Fits the Demco Trailer Coupler # DM99VR?
- Q&A: Needing a Repair Kit for a Bulldog Trailer Coupler
- Q&A: Replacing Lippert 5,200 lb Axle with Dexter 5,200 lb Axle 86.5 Inches Hub Face to Hub Face
- Q&A: Is 76" Spring-Center Measurement Abnormal for 95" Wide Trailer Axle
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Tire Sizing
- Article: Trailer Hitch Receiver Sizes