Remote For GoPower GP-SW3000 Inverter
Question:
I have a GoPower GP-sw3000 inverter. I purchased the remote gp-isw-r-12. With the inverter switch set to remote. A. There are no lights on the remote. B. If I push and hold the power button the inverter powers on and will work. But there are no lights on the remote and once I let off the button, the inverter shuts off. Any troubleshooting steps I can do? I have a video but cannot upload Thanks, Don
asked by: Don W
0
Expert Reply:
Unfortunately you have the ISW remote, which is the wrong one for your GoPower GP-SW3000 converter. What you need is the Remote for Go Power Pure Sine Wave Inverters # 34266886.
expert reply by:
Kyle S
0
![Kyle S](https://images.etrailer.com/static/images/catg/people/1237_tn.jpg)
Product Page this Question was Asked From
Remote for Go Power Pure Sine Wave Inverters - 150 to 3,000 Watt - 12V and 24V
- Accessories and Parts
- RV Inverters
- Remote Control
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Circuit Board for MaxxAir Fan 4951KSC
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Q&A: Recommended Inverter For Limited Use
- Q&A: Wire Size Used to Install MaxxFan Deluxe Roof Vent w/12V Fan & Thermostat MA00-05100K
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Q&A: What Is A Good Inverter For the 350-450 Price Range.
- Q&A: What is the TRC Port Used for?
- Q&A: Location of Brake Controller Port on 2015 Toyota Tundra
- Article: Where to Position the Trailer Axle?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 2023 Best Gifts for Auto Enthusiasts
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Stability Control for Heavy Duty Vehicles