Dimensions for Mounting Kit for Rhino-Rack Batwing Awning RR25FJ
Question:
Can you tell me the distance between the drilled holes, center to center, of the 3 drilled holes in the 6inch arm of the mounting bracket.
asked by: Jim L
0
Expert Reply:
I would be happy to! We have taken quite a few measurements of the brackets for the Mounting Kit for Rhino-Rack Batwing Awning item # RR25FJ. Pretty sure the spacing you're asking for is 1-3/8" but there are a lot of holes so I went ahead and attached a couple of diagrams below that I am confident will answer your question.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Mounting Kit for Rhino-Rack Batwing Awning - Tracklander Roof Tray
- Accessories and Parts
- Car Awning
- Mounting Hardware
- Batwing
- Rhino Rack
more information >
Continue Researching
- Q&A: Dimensions of Mounting Kit for Rhino-Rack Batwing Awning # RR25FJ
- Q&A: Comparison of Rhino-Rack Heavy-Duty and Rhino-Rack Vortex Aero Roof Racks
- Article: Trailer Maintenance Schedule
- Q&A: Will Honda Generator Fit In DeeZee Trailer Tongue Toolbox
- Q&A: Trailer Hitch Receiver Options For A Box Trailer Frame
- Q&A: Recommended Roof Rack for a Interstate 7X16 Cargo Trailer
- Q&A: Can Yakima CoreBar Crossbars Be Cut To Desired Length
- Q&A: Yakima HD Cross Bars T-Slot Dimensions
- Article: Trailer Wiring Diagrams
- Article: Basics of Tie-Down Anchors
- Article: Rooftop Cargo Carriers
- Article: Roof Rack Information