Troubleshooting Docking Lights Not Working With Switch on 2005 Lance 821
Question:
I have 2005 lance 821. Docking lights work with truck in reverse, but not with docking switch. I hear relay clicking, but no light
asked by: David C
0
Expert Reply:
It looks like there are 3 different fuses for the rear docking lights on your 2005 Lance 821. I'm assuming the power and backup fuses located in the exterior fuse panel are fine. This leaves the interior lighting circuit which is circuit #4 on the power distribution center. If that checks out then it is likely a short in the wiring.
expert reply by:
Robin H
0
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Dimensions of the Convert-A-Ball Cushioned Weight Distribution Shank # AMAC1
- Q&A: Distance from Pin Hole Center to End of Bar on Reese Weight Distribution Shank RP63971
- Q&A: 4-Way Vehicle Side Trailer Connector that Can be Spliced Into Wires from Trailer Wiring Harness
- Q&A: Should 12 Volt Hot Lead on 7-Way Trailer Connector Be Hot All the Time, WIll it Drain the Battery
- Q&A: Will 12V Wire at Vehicle End Trailer Connector Be Hot Even When Truck and All Lights Are Off
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers