Size and Torque Rating For The Mounting Studs On 10" x 2-1/4" Electric Brake Baking Plates
Question:
What size is the studs on a 10”x2-1/4” backing plate ? Also what’s the torque spec. ?
asked by: Garry L
0
Expert Reply:
The Mounting Hardware # BRKH10B for the 10" x 2 1/4" Brakes # AKEBRK-35-SA are 7/16"-20tpi. These should be torqued to 45-50ft-lbs.
expert reply by:
Bud M
0
Products Referenced in This Question
Mounting Hardware for 10" Brake Assemblies
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- Hydraulic Drum Brakes
- Hardware
- 10 Inch
- Redline
more information >
Product Page this Question was Asked From
etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Most Popular Wheel Bearings
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Parts Needed To Add Electric Drum Brakes To A Pontoon Trailer
- Q&A: Finding the Correct Electric Trailer Brake Assembly for Lippert Components 2800 lb Axle
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Are New Brake Drums Required if Replacing Electric Brake Assemblies on a Trailer
- Q&A: Replacement Trailer Brakes for Dexter 023-217-00
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes