Torque Spec for 2-5/16" Hitch Ball - 1" Diameter x 2-1/8" Long Shank
Question:
what should this ball be torqued at on a weight distribution hitch?
asked by: Deb M
0
Expert Reply:
The 2-5/16" Hitch Ball - 1" Diameter x 2-1/8" Long Shank # 63847 will need to be torqued to 450 ft-lbs. If you don't have a torque wrench that goes that high then you'll want to take the hitch ball to a garage and have them install it for you.
expert reply by:
Jon G
0
Product Page this Question was Asked From
2-5/16" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2-5/16 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 7500 lbs GTW
- Class III
- Draw-Tite
more information >
Continue Researching
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Comparing Tuson and Curt Electronic Sway Control Devices
- Q&A: Recommended Front Mount Hitch for a 2020 Chevy Silverado 3500 w/ a Diesel Engine
- Q&A: Recommended Front Mount Hitch For A 2020 Chevrolet Silverado 2500
- Article: My Trailer Hitch Doesn't Fit
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: How To Choose Correct Extended Length Ball Mount for 2" Hitch
- Q&A: Does Going With a Longer Ball Mount Cause Trailer to Handle Differently
- Q&A: How to Determine Weight Capacity of Trailer Axle
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Does Weight of Curt TruTrack Weight Distribution Hitch 17499 Need to Be Factored In
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: Steel vs. Aluminum Ball Mounts