What Should The Ohm Reading Be For 10" Electric Brake Assemblies
Question:
FOR 10 INCH BRAKES WHAT SHOULD THE OHM READING AT THE TRAILER PLUG BE FOR A DUAL AXLE TRAILER
asked by: SCOTT H
0
Expert Reply:
For a 10" brake assembly like the # AKEBRK-35-SA you should be reading 3.0-3.8 ohms.
expert reply by:
Jesse M
0
Products Referenced in This Question
etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- etrailer
more information >
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: All Parts Needed to Flat Tow 2014 Chevy Silverado 1500 Behind Motorhome
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Recommended Flat Towing Parts for a 2024 GMC Canyon Denali
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150