Are There Shorter Drop Leg Stabilizer Jacks Available For Limited Ground Clearance
Question:
Is there a shorter version than the 6 1/4inch stablizer. My enclosed trainer is low to the ground and I do not always have clearance to swing the stabilzer up.
asked by: David V
0
Expert Reply:
The Stabilizer Jacks - 6-1/4" Drop Leg # TJ01RT-HD are the shortest drop leg stabilizer jacks that we currently offer. The only other option that we currently have would be to switch to scissor jacks, like part # UF48-979002 to fit the smaller ground clearance.
expert reply by:
Kevin C
0
Products Referenced in This Question
Ultra-Fab Ultra Scissor Jacks - 24" Lift - 13,000 lbs - Qty 2
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Scissor Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 0 - 1000 lbs
- Drop Down Jack
- 18 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- etrailer
more information >
Continue Researching
- Shop: Ultra-Fab Ultra Scissor Jacks - 24" Lift - 13,000 lbs - Qty 2
- Article: Double-Eye Trailer Suspension System Review
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Slipper Spring Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Q&A: Install Instructions Link for Lippert Lift Kit # LC382741
- Q&A: Torque of Mounting Nuts on Lippert Torsion Axle Lift Kit
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Q&A: Installation Information for the Replacement Cables for Enclosed Trailer Ramp Spring # ERS160D96
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: Lug Nut Torque for a Trailer Wheel
- Article: Harvest Hosts
- Q&A: Repair Kit Fulton Wedge-Latch # F670801, Fits Fulton/Bulldog Couplers for 2-5/16 Inch Balls
- Article: Trailer Wiring Diagrams
- Article: What To Look For When Buying Ratchet Straps