What Lighting Function Runs to Optronics Light Bar # MCL97RB
Question:
I have a question about a center marker light for a over 80 inch wide trailer I bought from you . It has dual function marker and center brake light. Where do I connect the brake light wire? To the trailer brake circuit or to one or the stop lights. If it is connected to a stop light wouldnt the center light also blink if signaling a turn with the light it is connected to? Do you have a wiring diagram for the center light for the brake light function?
asked by: Phillip
Expert Reply:
I found your order notes and it looks like you bought the Optronics light bar part # MCL97RB which is actually a single function light. It only would have the running light circuit ran to it.
Product Page this Question was Asked From
Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 14L x 1W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Wire Solera Smart Arm 12V Power RV Awning
- Q&A: Replacement 4-Pin Switch for RV Awning
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Ranger Trailer Cool Hub Replacement Grease Seal AD2527E
- Q&A: Replacement Keys for etrailer Hitch And Coupler Locks With 029 Key Code
- Q&A: What are the Dimensions of Curt Hook with Spring Loaded Safety Latch # C81840
- Q&A: How To Wire In The V-Shaped Identification Light Bar When Replacing Light With Only 1 Wire
- Article: Trailer Lighting Requirements
- Article: Most Popular Wheel Bearings
- Article: Trailer Maintenance Schedule
- Article: Trailer Hitch Receiver Sizes
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Flat Towing Package for 2020 Jeep Wrangler