What Thread Size is the Kat's Heaters Custom Engine Block Heater # KH11407?
Question:
I am trying to use this in an ag application and need to know what size wrench this would use to take it out and also the pipe thread size
asked by: G. F
0
Expert Reply:
The Kat's Heaters Custom Engine Block Heater # KH11407 has a 1" NPT thread size. You will need to use a 1-3/8" wrench or socket to install the heating element.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Kat's Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 1" NPT
- Vehicle Heaters
- Engine Block Heater
- Frost Plug Style
- 400 Watts
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Q&A: Curt T-Connector Wiring Harness Taillight Connectors On a 2021 Jeep Grand Cherokee
- Q&A: Install Instructions for Kat's Block Heater KH11409
- Q&A: Can 2006 Nissan Xterra with Manual Transmission be Flat Towed
- Q&A: Where Does Kat's Engine Block Heater Install on 2014 Nissan Xterra
- Q&A: Wiring Diagram and Instructions for a Tekonsha Prodigy P3 Brake Controller
- Q&A: How to Measure if the Kats Heaters Engine Oil Dipstick can be Used on your Engine
- Q&A: Rebuild Kit Recommendation for Roadmaster 500 Stowmaster
- Article: Trailer Wiring Diagrams