What Circuit to Tap Into to Install the Hopkins Trailblazer Electronic Deer Alert # HM27512VA
Question:
I had one once installed and it was connected to the battery and the other wire to a fuse in the fuse box. I have a different car now and want to install another one. Can you tell me which fuse can be used? I did have it connected to a 20 amp fuse in my previous car.
asked by: Pat M
Expert Reply:
Basically you will want to look for a circuit that sees 12 volts when the vehicle is running an none when the vehicle is off. Common circuits are radio, ignition, traction control switch, power antenna.
Another way to wire the Hopkins Trailblazer Electronic Deer Alert # HM27512VA would be to wire it to the high beams circuit so that it activates when you turn your brights on.
Product Page this Question was Asked From
Hopkins Trailblazer Electronic Deer Alert
- Backup Camera
- Alerts and Sensors
- Hardwired
- Hopkins
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Where Should the Deer Alert Be Installed on a Vehicle
- Article: Curt Echo Full Review
- Q&A: 2012 Dodge Ram Brake Controller Plug Location
- Q&A: Will Hopkins Trailblazer Electronic Deer Alert # HM27512VA Work for Moose
- Q&A: Will The VueSMART RV And Backup Camera Work With An Aluminum Trailer
- Q&A: Operation and Sound of Deer Alert and Will it Bother a Dog Inside the Vehicle
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Battery Box Dimensions for Curt Push-To-Test Trailer Breakaway Kit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)