Can Outriggers be Used to Mount RV Steps with Different Mounting Holes
Question:
The holes in the mounting brackets of FMFP-2120 are 20 1/2 on center. I need 22 1/2 to match to the existing holes on my all-aluminum camper. How much additional width do each outrigger provide?
asked by: Jim M
0
Expert Reply:
The outriggers part # LC301704 aren't designed to compensate for narrower mounting holes so best option would be to drill new holes which you could use the outriggers to help with that.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Outriggers for Manual RV Steps
- Accessories and Parts
- RV Steps
- Outriggers
- Lippert
more information >
Continue Researching
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Installation of the Brake Buddy Classic 3, How to Provide Power
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Replacement Step Compatible with 2016 R-Pod Trailer for Low Rise
- Q&A: Replacement Steps for 2007 Monaco Dynasty RV
- Q&A: How To Install Lippert Outriggers To Your RV To Install New Pull Out Steps
- Q&A: How Can I Determine The Weight Capacity Of A 6 Lug Axle
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Q&A: RV Step Recommendation that Can Fit 27 inch Wide Mounting Brackets
- Q&A: How Long Does It Take to Install B&W Turnoverball Underbed Gooseneck Trailer Hitch BWGNRK1020
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Motorhome Steps
- Article: 7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money