Should B and W Biker Bar be Difficult to Get Bike Attached to
Question:
One question I want to ask. When the biker bar slides into the clamp it seems to be extremely tight. It doesnt just slide into the clamps easy like the videos show. I have to give a little throttle to get it to engage. Its so tight I cant push it in by hand. Is this normal ? Or is it supposed to slide easily into the clamp and engage easy ? I dont have any pictures of it at the moment. Thanks
asked by: Daryl
Expert Reply:
You might check to see if the setting of the clamp of your Biker Bar part # BWMC2301 needs to be adjusted. It sounds like there is a height difference that is causing the difficulty in getting the bar attached to the rest of the assembly.
Product Page this Question was Asked From
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can You Replace A GE Air Conditioner Be Replaced With An Advent A/C?
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Q&A: How to Determine the Correct Replacement Bearings for a Trailer
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Article: Big Truck Big RV
- Q&A: Replacement Key Needed for Gorilla Guard Trailer Coupler Lock
- Q&A: Factory Brake Wiring Harness Location on 2012 Chevy Silverado
- Article: Pintle-Hitches
- Article: Best Ladder Racks
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Performance Chips and Modules
- Article: How to Install E-Track in 3 Easy Steps