Can Horst Mircale Probe Sensors BE Used On A Holding Tank With 1/2" To 5/8" Thick Walls
Question:
Will the Horst Miracle Probe Tank Sensors work with a holding tank that has 1/2 to 5/8 inch thick walls?
asked by: Ray T
Helpful Expert Reply:
The gasket on the Horst Miracle Probe Sensors for RV Black Water Tanks # T21301VP is only about 1/4" in length so installing it in something thicker could potentially allow waste water to leak back into the hole and possibly out from the gasket. That being said, you could also caulk around the gasket on the outside of the tank to prevent any leaks. The key is really just making sure that the sensor is in enough to actually touch the water. If it sits back inside the hole there's also the chance that the some water or solid waste could get in the hole as well and cause the sensor to constantly think there's water up to its level.
Product Page this Question was Asked From
Horst Miracle Probe Sensors for RV Black Water Tanks - Qty 4
- Smart RV
- Monitoring System
- Water Tanks
- No Display
- Valterra
more information >
Continue Researching
- Shop: Horst Miracle Probe Sensors for RV Black Water Tanks - Qty 4
- Q&A: What is Difference Between Furrion and Voyager Observation Pre-Wiring
- Q&A: Replacing Black Water Tank Sensors
- Q&A: Wiring An Atwood RV Water Heater With Double-Panel On/Off Switch
- Q&A: Replacement Remote For a HappiJac Electric Camper Jack System
- Q&A: Wiring Replacement 7-Way Connector on 2004 GMC Yukon Denali
- Q&A: Programming Replacement Lippert LINC Remote
- Q&A: When Should Trailer Wheel Bearings be Replaced
- Article: Trailer Wiring Diagrams
- Article: Ram Trailer Tow Prep Package
- Article: Flat Towing Package for 2015 Ram 1500
- Article: Trailer Maintenance Schedule
- Article: Determining Trailer Tongue Weight
- Article: How Much Solar Power Do I Need For My RV?
- Article: Which RV Propane Tank Size Do I Need?