Replacement 1,600 psi Hydrastar Disc Brake Actuator for Trailer
Question:
I bought your Kodiak and dynastar hydraulic brake set up to get rid of the magnetic drums. Currently trailer has no brakes. I bought this approximately 3years ago. If the pump is burned out which one do I need? I think I have the 1600 psi with the 6 brakes. This is for a snow mobile trailer.
asked by: John
0
Expert Reply:
For your setup now the correct replacement actuator would be the part # HBA16 that you referenced. This provides the 1,600 psi you need and can support 6 brake assemblies.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hydrastar Electric Over Hydraulic Actuator for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- 1600 psi
- Disc Brakes
- Hydrastar
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Are 1/2-20 Lug Nuts Able To Be Used On M12-1.5" Wheel Studs?
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Troubleshooting Trailer Lights Which are Not Working
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Correct Replacement Oil Seal 225255UC for Ranger Boat Trailer
- Q&A: Can Dexter E-Z Flex Suspension Kit Replace Dexter 13-10 Equalizer
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: Bolts and Bracket for the Tie Down Caliper to Kodiak Caliper
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer