Best Way to Get Vehicle On 10" Race Ramps Wheel Cribs
Question:
Would I use a jackstand to raise the tires up high enough to get these under or is there a ramp I use to drive up and then set inside these?
asked by: Donny
0
Expert Reply:
Ideally you'll use jack stands to lift your vehicle high enough to get the 10" Race Ramps Wheel Cribs # RR-WC-10 in place. You could probably use ramps as well but it would make me nervous transferring off of ramps onto these which is why I recommend the jack stand approach.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Race Ramps Wheel Cribs for Service and Display - 10" Lift - 15" Long - Qty 2
- Car Ramps
- Storage and Display Ramps
- 12 Inch Wide
- 10 Inch Lift
- 15 Inch Long
- Display Ramps
- 3000 lbs
- Race Ramps
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Wiring Diagram for Trailer Wiring 6-Way
- Q&A: How to Wire a 6 Pole Round Trailer End Plug
- Q&A: 7-Way RV Trailer Connector Wiring Diagram
- Article: Must-Have Flat Towing Components
- Q&A: What is the Difference Between the Brake Buddy 2 and Brake Buddy 3
- Q&A: Solution for 28 Inch Long Replacement Leaf Spring
- Q&A: Will Overrated Slipper Springs Cause Rigid Ride