Troubleshooting Solid Red Light on Lippert Replacement Controller V-Sync II
Question:
When sliding out, one motor stops after a couple seconds. When I check the controller, there is a solid red light for about 10 seconds then the light clears. No blinking green or red, just solid red then no light. When the light clears, I can run the slide the rest of the way out. No problems bringing the slide back in. I have a brand new battery and can detect no kinks in the wires. I did reset the controller and still have the same issue. The track looks clean. Any advice on what to do next would be appreciated.
asked by: Eric K
Expert Reply:
If the controller you have is the part # LC211852 that is showing a solid red light that would indicate the controller is bad since that is not a standard fault code. You would need to replace it with the # LC211852.
Product Page this Question was Asked From
Lippert Replacement Controller for In-Wall Slide-Out - V-Sync II
- RV Slide Out Parts
- Controller Parts
- Controller
- Lippert In-Wall RV Slide-Out Systems
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Measure Hub Face of Mobile Home Hub and Drum
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Article: Trailer Maintenance Schedule
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: How Long Can You Boondock in an RV?
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: Hanger Spacing Dimensions for Installing Double-Eye Leaf Springs on a Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Stability Control for Heavy Duty Vehicles
- Article: Gooseneck Trailer Hitch Information and Review