Does The Pin Assembly On The Pollak 6-Pole Socket PK11609 Push Out The Front Or Back
Question:
Is the pin assembly of the 6-pin socket pushed out of the front or pulled out of the rear? I want to add a wire.
asked by: Phill F
0
Expert Reply:
The pin assembly on the Pollak 6-Pole Socket # PK11609 will push out the front of the socket. I have linked one of our install videos below. If you fast forward to about the 2:30 mark you can see the installer disassemble to socket.
expert reply by:
Jesse M
0
Products Referenced in This Question
Pollak 6-Pole, Round Pin, Trailer Wiring Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Trailer Wiring Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Comparing etrailer and Blue Ox Baseplate Kits For A 2023 Jeep Gladiator
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Brake Lights Overriding Tow Bar Lighting Turn Signals
- Q&A: Can Curt Tow Bar Lighting Kit for 2023 Jeep Gladiator Install with Trailer Wiring
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Does Hopkins Tow Bar Lighting Kit of 2017 Jeep Wrangler Control Brake Lights
- Q&A: Tow Bar Lighting Solution for 2023 Jeep Wrangler that Allows Charge for Battery
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Article: Brake Controller Installation: Starting from Scratch
- Article: Tow Bar Wiring Overview
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Tow Bar Wiring: Which Wiring Kit is for You?